 Thindor Wall & Ceiling access panels are the non fire rated budget range of our Zintec steel door access panels
The door tray is formed from 1.0mm thick Zintec and the frame formed from 1.2mm thick Zintec.
Comprising spring loaded pins and pivot hinges to allow easy removal of the door
Manufactured to 25mm deep and supplied with either a 25mm wide picture frame surround giving an architrave finished appearance or a 25mm wide beaded frame for taping & jointing on site to conceal the frame
The Thindor panels have a budget locking mechanism with a budget lock key accessory and come complete with a plastic cap to conceal the key hole when not in use.
Access Panels are finished polyester powder coated RAL 9010 with a textured finish to allow for painting on site where required. Other RAL colours are available upon request at an extra cost.
Bespoke sizes are available upon request |
Standard Sizes EX Stock available for next day delivery
Height |
x |
Width |
|
|
|
200mm |
x |
200mm |
300mm |
x |
300mm |
450mm |
x |
450mm |
550mm |
x |
550mm |
600mm |
x |
600mm |
| |
|
|
NOTE: Add 10mm to the above sizes for the structural opening size
Applications
Forming Apertures
A clear aperture in the above structures should be formed at the access point to sizes of, (H + 10mm) x (W + 10mm)
Masonry applications - pack out the opening with max of 15mm thick timber linings where necessary.
Ceiling applications - ensure aperture framing members (A) in the M/F suspension system are sufficiently deep enough for span purposes and for the purpose of screw fixing the panel frames PF and BF to A’s webs.
Fixing Details
1) Unlock the door as described in Operation.
2) Remove door from the frame by releasing the nuts on welded M6 screws (Retain in a safe place)
3) Offer frame into aperture formed as described in above Forming Apertures.
4) Screw fix through pre-punched holes in both frame sides (Width) to the aperture reveal.
5) Ensure that the panel is square by fixing shims between frame and aperture as needed.
6) Replace door by locating hinge over welded screws and re-fix using washers and nuts previously retained.
7) Lock door as across Operation details.
Operation
Opening:
1) Remove plastic plug from key hole with fingernail lift.
2) Insert budget lock key into key hole and turn anti-clockwise supporting the weight of the door.
Closing:
1) After leading edge of door enters panel frame insert budget lock key into key hole and turn clockwise.
2) Replace plastic plug into key hole.
|
